FT 7900R MANUAL PDFJuly 31, 2020
Compact FTR Mini-Manual. Size, x8 inches. Twelve high-quality laminated pages, loaded with detailed instructions covering all aspects of operating. FTR/E Technical Supplement Dual Band FM Transceiver FTR/E Technical Supplement Introduction This manual provides technical. Yaesu FTR Amateur Transceiver. #, Nifty Mini Manual, MINI MANUAL, Nifty spiral bound mini-manual contains 12 laminated pages [ x 8 inch].
|Published (Last):||23 May 2009|
|PDF File Size:||7.20 Mb|
|ePub File Size:||14.67 Mb|
|Price:||Free* [*Free Regsitration Required]|
Frequency ranges will vary according to transceiver ver- sion; check with your dealer. Packet Interface Cable Availability of accessories may vary. Some accessories are supplied as standard per local requirements, while others may be unavailable in some regions.
Consult your Yaesu dealer for details regarding these 77900r any newly-available options Connection of any non-Yaesu- approved accessory, should it cause damage, may void the Limited Warranty on this appa- ratus.
Do not install the transceiver on top of another heat-generating mabual such as a power supply or amplifierand do not place equipment, books, or papers on top of the FTR. Avoid heating vents and window locations that could expose the transceiver to excessive direct sunlight, especially in hot climates. These safety tips apply to any device installed in a well-designed amateur radio station. The antenna or a 50 Ohm dummy load should be connected whenever the transceiver is turned on, to avoid damage that could otherwise result if trans- mission occurs accidentally without an antenna.
The use of the shortest possible length of the highest quality coaxial cable that fits within your budget will ensure the best performance maanual your FTR. Mount the transceiver where the display, controls, and microphone are easily accessible, using the supplied MMB mounting bracket.
The transceiver may be installed in almost any location, but should not be positioned near a heating vent nor anywhere where it might interfere with driving either visually or mechani- cally. Other external speakers may be used with the FTR, if they present the specified 8-Ohm impedance and are capable of handling the 2 Watts of audio output supplied manuaal the FTR.
The pin connections of the Data connector are shown below. If you have trouble getting your FTR to respond correctly during packet operation, check to be certain that you do not have Menu 26 PKT.
Press this key momentarily to change the Tone Squelch mode: Press or hold in either of these buttons to tune or scan up or down the operating frequency or through the memory channels. In many ways, these buttons emulate the function of the rotary DIAL knob.
See page 62 for details. See page 73 for details. Clockwise rotation of the DIAL knob causes the FTR to be tuned toward a higher frequency, while counter-clockwise rotation will lower the operating frequency.
These power levels will be stored, in memory registers, at the time of memory storage see page 32 for details on Memory operation. The brightness of the display is manually adjustable, using the following procedure: However, if you need to change the channel step increments, the procedure to do so is very fy While the MHz shift will be kHz; on 70 cm, the shift may be 1.
Enter the transmit and receive fre- quencies separately, as shown on page FM carrier in order to activate the repeater. This helps prevent false activation of the repeater by radar or spurious signals from other transmitters.
Programming The FT-7900R
When this happens, it may be that the other station is not sending any tone. To return to normal operation, repeat the above steps. In the event of extreme weather disturbances, such as storms and hurricanes, the NOAA National Oceanic and Atmospheric Administration sends a weather alert accompanied by a Hz tone and subsequent weather report on one of the NOAA weather channels.
It will halt on signals encountered, so you can talk to the station s on that frequency, if you like. If you want to change direction of the scan while it is underway, rotate the DIAL knob one click in the opposite direction in this case, one click counter- clockwise.
YAESU FT-7900R Operating Manual
When the Memory Bank feature is activated, the FTR will check the lowest memory channel in the Memory Bank as the priority channel. Press and hold in the [ S. These DTMF Autodialer memories can store up to 16 digits of a telephone number for repeater autopatch or other uses. 79900r disable the Internet link feature, press the [ L ] key again. Select the scan mode. This requires a user-constructed Cloning cable which connects the DATA jacks on the two transceivers, as shown below.
To clone from one transceiver to another, use the following procedure: It may be used for configuration of a wide variety of transceiver parameters, some of which have not been detailed previously.
Programming the FTR
Use the following procedure to activate the Set Menu mode: Selects or disables the VFO band edge limiting for the current band. Depends on the band of operation. Selects the Receiving mode. Menu 6 [ CLK. Shifting of CPU clock frequency. See page 56 for details. Menu 15 [ EDG.
Selects the Memory Scan channel-selection mode. The scanner will only scan channels that are flagged Preferential Scan List.
Menu 42 [ SQL. This Menu Item can manuql set independently for each band. Changes the Tone Squelch Reverses the transmit and re- mode. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions; 1 This device may not cause harmful interference, and 2 this device must accept any interference including received, interference that may cause undesired operation.
Page of 84 Go. Notting HillVictoria, Australia. Table of Contents Add to my manuals Add.
Specifications AF Output Impedance: Installation Do not install the transceiver on top of another heat-generating device such as a power supply or amplifierand do not place equipment, books, or papers on top of the FTR. Page 9 The use of the shortest possible length of the highest quality coaxial cable that fits within your budget will ensure the best performance from your FTR.
Mobile Power Connections Yaesu dealer. Rear Panel Connections 10 Amperes continuous duty. Page 19 Press or hold in either of these buttons to tune or scan up or down the operating frequency or through the memory channels. Page 30 FM carrier in order to activate the repeater. Tone Search Scanning When 790r happens, it may be that the other station is not sending any tone.
Regular Memory Channel Operation 4. Memory Bank Operation CH Memory Only Mode 3. Programmable band Limit Memory Scan 7. Priority Channel” Scanning dual Watch 4. Wx Priority WX Priority 1. Smart Search see above. Arts Polling Time Options see above. Cw Identifier Setup Page 59 4. Page 61 to establish the link to the Internet link repeater.
Miscellaneous Settings the default selection. Page 70 Selects or disables the VFO band edge limiting for the current band. Page 71 Selects the Receiving mode. Page 72 Disable the beeper. Page 78 Menu 42 [ SQL. Auto” Mode Preset Operating Parameters Comments to this Manuals Your Name. Enter text from picture: By pressing ‘print’ button you will print only current page. To print the manual completely, please, download it. Don’t show me this message again. Got it, continue to print.
Don’t have an account?